8/4/2023 0 Comments Mtu nano enterprise![]() ![]() The bridge network is the default network for new containers. $ ip aģ: docker0: mtu 1500 qdisc noqueue state DOWN group default You can also use the ip command to view details of the docker0 bridge. You can see that it has no interfaces currently connected to it. ![]() This is the bridge that was automatically created for the bridge network. ![]() The output above shows a single Linux bridge called docker0. # Install the brctl toolsīridge name bridge id STP enabled interfaces Install the brctl command and use it to list the Linux bridges on your Docker host. This is true of all networks using the bridge driver – the bridge driver provides single-host networking.Īll networks created with the bridge driver are based on a Linux bridge (a.k.a. This means that the network only exists on this Docker host. The output above also shows that the bridge network is scoped locally. In this example the network and the driver have the same name – but they are not the same thing! It’s important to note that the network and the driver are connected, but they are not the same. The output above shows that the bridge network is associated with the bridge driver. Verify this with the docker network ls command. You will need all of the following to complete this lab:Įvery clean installation of Docker comes with a pre-built network called bridge.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |